Fluke 3130 - Maintenance; User-Replaceable Parts and Accessories

Portable Pressure Calibrator
Remote Operation
35
Table 4. Product Commands (cont.)
Command Description
PRES_UNIT Set the pressure unit for the indicated display
PRES_UNIT? Shows the pressure from the indicated display
PUMP_LIMIT Sets the approximate value at which the pump will turn off
PUMP_LIMIT? Shows the approximate value at which the pump will turn off
REMOTE Puts the Product in remote mode
SIM Set the Product to simulate the requested current
SIM? Shows the value of the current being simulated
ST_CLOSE? Shows pressure value at which the switch closed
ST_DEAD? Shows pressure value of the deadband of the switch
ST_OPEN? Shows pressure value at which the switch opened
ST_START Starts a switch test
VAL? Shows the measured values
ZERO_MEAS Zeros the pressure module
ZERO_MEAS? Shows the zero offset of the pressure module
Table 5. Parameter Units
Units Meaning
DCI Current function
DCV Voltage measure function
EXT External pressure measurement function
LOWER Designates Lower display
MA Milliamps of current
MEASURE Measure state
MEAS_LOOP Measure with loop power state
MIDDLE Designates Middle display
PCT_ERR Percent Error
PERCENT Percent
P1 P1 pressure measurement function
ST_P1 Switch test mode with P1
ST_EXT Switch test mode with external module
SOURCE Source state
SIM Simulate state
UPPER Designates Upper display
V Voltage