Fluke 3130 - Remote Operation

Portable Pressure Calibrator
Storage Capability
29
Storage Capability
The Product has a min/max feature to capture the minimum and maximum values of a
shown parameter.
The min/max function can be accessed by going through the menu options until the
MINMAX menu choice is shown. Push the MINMAX softkey to see the min/max values
that are stored in the min/max registers. These readings are live so that the new min/max
values are recorded while in this mode.
To reset the min/max registers, push the CLEAR softkey. These registers are also cleared
at power-up or when the configuration is changed.
Remote Operation
The Product can be remotely controlled with a PC terminal, or by a computer program
that runs the Product in an automated system. An RS-232 serial port connection is used
for remote operation.
Note
To use the remote control option, a custom RS-232 cable must be
purchased. See the “How to Contact Fluke Calibration” section.
With this connection, you can write programs on the PC. Use Windows languages like
Visual Basic to operate the Product, or use a Windows terminal like Hyper Terminal, for
single commands. A typical RS-232 remote configuration is shown in Figure 35.
V mA
SWITCH TEST
COM
EXTERNAL
PRESSURE MODULE
24 V DC
30 V MAX
LOOP
PORTABLE PRESSURE CALIBRATOR
3130
FLUKE CORPORATION
EVERETT, WA USA
www.flukecal.com
CHARGE
16 V DC
5.6 A
SERIAL NO.
VENT LINE BEFORE MAKING SELECTION
CAUTION
OUTPUT
ISOLATION
VALV E
-12 PSI TO 300 PSI
(-8 kPa TO 2 MPa)
AIR SUPPLY
330 PSI MAX
(2.3 MPa)
PRESSURE
CLOSED
VACUUM
PUMP
FINE
ADJUSTMENT
VENT
SUPPLY
METERING VALVE
FINE
ADJUSTMENT
VENT
FILTER
PRESSURE
SENSOR
CLOSE VALVE BEFORE
OPERATING PUMP
F1 F2 F3
HOME
ZERO PUMP
COM Port
hbb034.eps
Figure 35. Remote Operation