Fluke 3130 - Introduction

1
Introduction
The Fluke 3130 (the Product) is a portable pressure calibrator that can use two methods
to source pressure:
• An internal, electronic pump that has a range of -12 psi to 300 psi (-0.8 bar to 20 bar)
• An external connection that lets you use externally-sourced, clean, dry air to regulate
pressures to a maximum of 300 psi
Product features include:
• A built-in needle valve for metering in pressure
• Variable volume for small pressure changes
• An internal pressure sensor
• Measurement of 0 V dc to 30 V dc and 0 mA to 24 mA from a unit under test (UUT).
• Sourcing current of 0 mA to 24 mA to a UUT also available
• A 24 V dc loop power supply that uses dedicated front panel jacks. For voltage
transmitters, a dedicated 24 V dc loop power supply is available in volts measure
mode. mA loop power is supplied from the left-most jacks.
• An internal, high-capacity NiMH battery
• A universal power supply (90 V ac to 250 V ac) that can charge the battery pack
while it powers the Product
• Pressure measurement with the internal pressure sensor or with a Fluke 700 Series
external pressure module
• The Product can show pressure units in these different values:
• psi
• MPa
• kPa
• inHg 0°C
• mmHg 0°C
• kg/cm
2
• mmH
2
O 4°C
• mH2O20°C
• inH
2
O 4°C
• inH
2
O 60°C
• cmH
2
O 4°C
• cmH
2
O 20°C
• bar
• mbar