3130
Users Manual
34
Table 4. Product Commands
Command Description
DAMP Turns on or off Damp
DAMP? Show if DAMP is on/off
DISPLAY Turns on or off the displays specified in the command
DISPLAY? Shows which displays are on/off
ERROR_LOOP Turns on or off loop power in percent error mode
ERROR_LOOP? Shows the current state of loop power in error mode
ERROR_MODE Turns on or off percent error mode
ERROR_MODE? Shows if percent error mode is on or off
ERROR_PORT Set the pressure port for percent error mode
ERROR_PORT? Shows the pressure port for percent error mode
FAULT? Shows the most recent error code
FUNC Sets the display mode as specified in the command
FUNC? Shows the current mode of the upper, middle, and lower display
HART_ON Turns on the HART resistor
HART_OFF Turns off the HART resistor
HART? Shows the current state of the HART resistor.
HI_ERR Sets the 100 % of span limit for percent error mode
HI_ERR? Shows the 100 % of span limit for percent error mode
IO_STATE Set the Product mA state
IO_STATE? Shows the Product mA state
LOCAL Shows user to manual operation of the Product
LOCKOUT Locks out the keypad of the Product in remote operation
LO_ERR Sets the 0 % of span limit for percent error mode
LO_ERR Shows the 0 % of span limit for percent error mode
MOTOR_ON Turns on the motor
MOTOR_OFF Turns off the motor
MOTOR? Shows the current state of the HART resistor
OUT Set the Product to output the requested current
OUT? Shows the value of the current being simulated
To Next Page
Loading...
