Fluke 381 - AC and DC Voltage

Remote Display True-rms Clamp Meter
Maintenance
19
Maintenance
Clean the Product
WCaution
To prevent possible damage to the Product or to equipment
under test, do not use abrasive cleaners. They will damage the
case.
To clean the Product, use a cloth with a mild cleaning solution.
Battery Replacement
XW Warning
To prevent possible explosion, fire, or personal injury, Replace
the batteries when the low battery indicator ( or
) shows to prevent incorrect measurements.
WCaution
To prevent possible damage to the Product or to equipment
under test:
• Remove batteries to prevent battery leakage and damage to
the Product if it is not used for an extended period.
• Be sure that the battery polarity is correct to prevent battery
leakage.
To change the batteries, see Figure 8:
1. Make sure the Product is OFF.
2. Turn the Product over to access the battery compartment door screw.
3. Use a flat-head screwdriver to loosen the battery compartment door screw and lift off
the battery compartment door.
4. Replace the three AA batteries.
5. Reattach the battery compartment door.
6. Tighten the battery compartment door screw.