Fluke 45 User Manual

Operating the Meter From the Front Panel
Display
3
3-3
REMOTE
EXT TRG
SMF MAX
MIN
dB
HOLD
REL
AUTO
mA
mVDCAC
Mk
Hz
UNCAL
mA
mV
DC AC
Hz
Mk
Remote State
with or without
Front Panel Lockout
(REMS or RWLS))
External
Trigger
Enabled
Reading Rate:
Slow, Medium, Fast
MIN MAX
Modifier
Decibels
Modifier
Touch Hold
Modifier
Relative
Modifier
Autorange
Continuity
Test
Function and Unit
Annunciators
Calibration
Corrupted
Diode Test
Less Than
1/2 Hour Battery
Power Remains
Overload, Out of Limits.
(Placement of Decimal
Point Varies According
to Range.)
Diode Test
W
aam10f.eps
Figure 3-2. Display Annunciators
UNCAL
mA
mV
DC AC
Hz
Mk
DUAL DISPLAY MULTIMETER
45
aam11f.eps
Figure 3-3. Secondary Display
If the secondary display has been turned on, press a function button (white) to select a
measurement function for the secondary display. The reading in the primary display will
not be affected. When the secondary display is active, pressing any function button turns
off the secondary display and selects that function on the primary display. To turn the
secondary display off without affecting the primary display, press S twice.
Note
If you press G, only a diode test voltage reading will be shown in the
secondary display; continuity is restricted to the primary display.

Fluke 45 Specifications

General

Diode Test	Yes
Display Digits	5 digits
Interface	RS-232
Frequency Range	5Hz to 500kHz
Continuity	< 25 Ω
Basic DC Accuracy	0.05%
Power Supply	115/230 V AC, 50/60 Hz