5080A
Getting Started Manual
2
Symbols used on the Calibrator and in this manual are explained in Table 1.
Table 1. Symbols
Symbol Description Symbol Description
B AC (Alternating Current) J Earth Ground
W Important Information: refer to manual X Shock Hazard
P Complies with EU directives )
Complies with relevant North
American Safety Standards.
CAT I
IEC Measurement Category I – CAT I
is for measurements not directly
connected to mains. Maximum
transient Overvoltage is as specified by
terminal markings.
~
Do not dispose of this product as
unsorted municipal waste. Go to
Fluke’s website for recycling
information.
This manual contains information, warnings, and cautions that must be followed to
ensure safe operation and to maintain the Calibrator in a safe condition.
XW Warning
To avoid possible electric shock or personal injury, follow these
guidelines:
• Use this Calibrator only as specified in this manual or the
protection provided by the Calibrator might be impaired.
• Do not apply more than 264 V ac rms between the supply
conductors or between either supply conductor and ground.
• Use caution when working with voltages above 30 V ac rms,
42 V peak, or 60 V dc. These voltages pose a shock hazard.
• Ensure the Calibrator is in STANDBY by pressing the RESET
key before disconnecting test leads.
• Ensure the grounding conductor in the power cord is
properly connected to a protective ground. The output
terminals are clamped to the earth referenced chassis and
rely on the protective earth bond to limit accessible voltage
to the operator. Any disruption of the protective earth could
place lethal voltage onto the chassis of the Calibrator due to
abnormal output terminal configuration or mains transient
condition.
• Use only the replacement fuses specified by the manual.
• Do not position the Calibrator such that the power cord
cannot be accessed in the event of an emergency. In the
event that customer installation interferes with access to the
power cord, a suitable power disconnection switch shall be
provided by the customer.
• Use only the power cord and connector appropriate for the
voltage and plug configuration in your country.
riešenia na presné meranie
To Next Page
Loading...
