1
Getting Started
WX Warning
If the 5080A Calibrator is operated in any way not specified by
this manual or other documentation provided by Fluke, the
protection provided by the Calibrator may be impaired.
The 5080A Calibrator is a fully programmable precision source of the following:
• DC voltage from 0 V to ±1020 V.
• AC voltage from 1 mV to 1020 V, with output from 45 Hz to 1 kHz.
• AC current from 29 μA to 20.5 A, with variable frequency limits.
• DC current from 0 to ±20.5 A.
• Discrete resistance values from a short circuit to 190 MΩ.
Features of the 5080A Calibrator include the following:
• Automatic meter error calculation.
• X and D keys that change the output value to pre-determined cardinal values for
various functions.
• Programmable entry limits that prevent entering invalid amounts.
• Simultaneous output of voltage and current, up to an equivalent of 20.9 kVA.
• Simultaneous output of two voltages.
• Variable phase signal output.
• EIA Standard RS-232 serial data interface for printing, displaying, or transferring
internally stored calibration constants, and for remote control of the 5080A.
Safety Information
This Calibrator complies with:
• ANSI/ISA-61010-1 (82.02.01)
• CAN/CSA C22.2 No. 61010-1-04
• ANSI/UL 61010-1:2004
• EN 61010-1:2001
In this manual, a Warning identifies conditions and actions that pose a hazard to the
user. A Caution identifies conditions and actions that may damage the Calibrator or the
equipment under test.
riešenia na presné meranie
To Next Page
Loading...
