Calibrator
Rear-Panel Features
23
29
27
28
26
24
25
23
gew325f.eps
Figure 5. Front-Panel View (cont.)
Table 4. Front-Panel Features (cont.)
W
I
The I (Polarity) key changes the polarity of the output for dc voltage or dc current functions.
Press the I key then E to toggle the output polarity.
X
The MegOhm terminals are used for high resistance sourcing. This button is active only when a
MegOhm option is installed.
Y
The SCOPE TRIG (Scope Trigger) BNC connector is used to trigger the oscilloscope during
oscilloscope calibration. This is active only when an oscilloscope option is installed.
Z
The SCOPE OUT (Oscilloscope) BNC connector is used for outputs during oscilloscope
calibration. This is active only when an oscilloscope calibration option is installed.
a
The 20A terminal is the source of current output when the 20 A range is selected (3 A - 20 A).
b
The AUX (Auxiliary Output) terminals are used for ac and dc current outputs, the second voltage
output in dual voltage modes, and ohms sense for 2-wire and 4-wire compensated resistance.
c
The NORMAL (Normal Output) terminals are used for ac and dc voltage, ohms.
riešenia na presné meranie
To Next Page
Loading...
