Fluke 5320A - Rear-Panel Features

5320A
Getting Started Manual
20
Rear-Panel Features
Table 7 lists the items found on the Calibrator’s rear panel.
Table 7. Rear-Panel Features
POWER INPUT
100V - 240V
250 VA MAX.
FREQ 47 - 63 Hz
IEEE-488
NOTE
NO USER SERVICEABLE PARTS CONTAINEDWITHIN,
DO NOT REMOVE COVERS, HAZARDOUS VOLTAGES PRESENT.
REFER SERVICETO QUALIFIED PERSONNEL.
SAFETY WARNING
DISCONNECT POWER AND SIGNAL LEADS
BEFORE REMOVING COVERS.
FOR CONTINUED PROTECTION AGAINST ELECTRIC SHOCK
THE POWER CORD PROTECTIVE CONDUCTOR MUST BE
CONNECTED TO SAFETY EARTH ( GROUND ).
FOR CONTINUED PROTECTION AGAINST FIRE
USE 250V FUSE OF CORRECT RATING.
READ MANUAL BEFORE USE.
AUX PROTECTIVE
EARTH (GROUND)
TO CLEAN AIR FILTER :
DISCONNECT POWER
REMOVE FILTER
FLUSH WITH SOAPY WATER
DRY BEFORE REINSTALLATION
LAN RS-232
LINE SELECTOR
115 / 230V
LOOP / LINE IMP.
T20AH 250V
METER
T32AH 150V
RCD
T4AH 250V
POWER FUSE
T2AH 250V - 230V
T4AH 250V - 115V
FLUKE CORPORATION
www.fluke.com
LEAKAGE CURRENT
T100mAH 250V
1
7 58910 4
6
2
3
elv002.eps
Item Description
A Fan Filter The filter covers the air intake to keep dust and debris out
of the chassis. A fan inside the Calibrator provides a
constant cooling air flow throughout the chassis.
B Line Power Fuse Holder The line power fuse. Refer to “Accessing the Fuses”
earlier in this manual.
C Signal Fuse Holders These fuses protect the signal outputs and inputs. Refer
to “Accessing the Fuses” earlier in this manual.
D Line Voltage Selection Switch Selects the line voltage. Refer to Selecting Line Voltage
earlier in the manual.
E AC Power Input Connector A grounded male three-prong connector that accepts the
line power cord.
F AC Power Switch Turns Calibrator ac power on and off.