Maintenance
Error Codes 4
4-9
Error Codes
The Product error codes are listed below.
0-Level Faults: Error handling
0 No Error
1 Error Queue Overflow
2 Bad ERR Channel
100-Level Faults: Self-calibration
100 Invalid Procedure Number
101 No Such Step In Procedure
102 No Cal/Diag Procedure Underway
103 Cal/Diag not Halted
104 No Cal Step To Which To Back Up
105 No Such Position For Range Under Cal
106 No Such Range For Cal Procedure
107 DAC %s Calibration Failed
108 Entered Reference Outside Of Limits
109 Measured And Entered Input Don't Match
110 Frequency Doesn't Match Expected
111 Input Is Of Wrong Polarity
112 Input Is Changing During Cal
113 Input Tripped Protection Circuit
114 Constant %s Out Of Limits
115 Flatness Constant Out Of Limits
116 Range Gain Constant Out Of Limits
117 Rough Gain Constant Out Of Limits
118 Offset Constant Out Of Limits
119 Low F AC Constant Out Of Limits
120 %s Range Zero Out Of Limits
121 %s Range Shunt Offset Out Of Limits
122 Divide By 0 %s IA Update
123 Old %s IA Is Way Off! Do A DC Cal
124 Temperature Gain Is Zero!
125 New Temperature Zero Out Of Limits
126 Cal State Must Be Unsecured and in Service Mode
To Next Page
Loading...
