Fluke 5790B - 200-Level Faults: Hardware configuration; 300-Level Faults: Inguard processor; 400-Level Faults: Self-diagnostics

5790B
Service Manual
4-10
127 INPUT2 Correction Factor Out Of Limits
128 Calibration Step In Progress
129 Must Do Wideband Reference Correction First
130 Cable Calibration Failed
150 Calibration Procedure Complete
199 Cal Error Occurred; Already Reported
200-Level Faults: Hardware configuration
200 Need A %s To Do That
201 Need Wideband AC Option To Do That
202 IG Software Out Of Date: Use %s Or Newer
300-Level Faults: Inguard processor
300 A17 Guardcrossing: ROM Checksum
301 A17 Guardcrossing: RAM
302 A17 Guardcrossing: DUART
303 A17 Guardcrossing: Watchdog
304 Hardware Initialization
400-Level Faults: Self-diagnostics
400 %s
401 A16 DAC: Channel Ratio
402 %s
403 A15 A/D: Selftest
404 A15 A/D: %s Zero
405 A15 A/D: Null DAC %s
406 A15 A/D: DAC %s
407 A15 A/D: Chopper %s
408 A10 Transfer: %s Range
409 A10 Transfer: %s Protection Check
410 A10 Transfer: Overload Check
411 A10 Transfer: Sensor Input/Output Match
412 A10 Transfer: %s Range Zero
413 A10 Transfer: %s Input Path
414 A10 Transfer: %s Frequency Measurement