Fluke 5790B - 500-Level Faults: Instrument state; 600-Level Faults: Firmware updater

Maintenance
Error Codes 4
4-11
415 A6 Wideband: %s Range
416 A6 Wideband: Overload Check
417 A6 Wideband: %s Frequency Measurement
418 A3 Motherboard: KV Divider %s
419 A10 Transfer: Sensor Loop Settling
420 A6 Wideband: Sensor Loop Settling
421 A16 DAC: DAC Settling
422 A6 Wideband: Dormant Protection Check
423 A15 A/D: %s Linearity
450 Diagnostics Procedure Complete
500-Level Faults: Instrument state
500 Bad Delta Unit
501 Invalid Range
503 Can't Set Ref
504 Can't Set Avg Ref
505 Can't Decode Learned String
506 Learned String Checksum Bad
507 Recalling Unsaved Instrument State
508 Already Printing A Report
509 External Guard Not Available
510 Display Brightness Setting Exceeds Limits
600-Level Faults: Firmware updater
601 Backup directory not specified in AuxInfo
602 Backup filename not specified in AuxInfo
603 Destination directory not specified in AuxInfo
604 Destination filename not specified in AuxInfo
605 Error extracting required file transfer data from AuxInfo
606 Error retrieving parameter value from AuxInfo
607 Error retrieving section name from AuxInfo
608 Interim directory not specified in AuxInfo
609 Interim filename not specified in AuxInfo
610 Error reading AuxInfo file
611 Source directory on USB device not specified in AuxInfo