Fluke 5790B - Page 116

5790B
Service Manual
4-12
612 Source filename on USB device not specified in AuxInfo
613 Can not build a list of sequences to be executed
614 Backup directory not specified in AuxInfo (config/cal)
615 Backup file not specified in AuxInfo (config/cal)
616 Destination directory not specified in AuxInfo (config/cal)
617 Destination file not specified in AuxInfo (config/cal)
618 Source directory not specified in AuxInfo (config/cal)
619 Source file not specified in AuxInfo(config/cal)
620 Error setting mode of new file
621 Timestamp too long in AuxInfo
622 Can not close updated file (config/cal)
623 Destination file does not exist (config/cal)
624 Can not get required AuxInfo parameters (config/cal)
625 Can not open new file (config/cal)
626 Failed to read the existing (destination) file (config/cal)
627 Failed to read the new (source) file (config/cal)
628 Can not remove existing backup file (config/cal)
629 Can not rename existing file to backup file (config/cal)
630 Source file does not exist (config/cal)
631 Invalid timestamp. Can not convert to epoch time
632 Kernel Datapath1 not specified in AuxInfo
633 Kernel Datapath2 not specified in AuxInfo
634 Kernel Device not specified in AuxInfo
635 Kernel Erase Command not specified in AuxInfo
636 Can not extract Kernel update data from AuxInfo
637 Kernel Offset not specified in AuxInfo
638 Kernel Read Command not specified in AuxInfo
639 Kernel Write Command not specified in AuxInfo
640 Kernel Device failed to close
641 Kernel Device failed to return info about device status
642 Kernel Device failed to open
643 Kernel Device failed to return status (error not used)
644 Unable to determine the size of the Kernel image file
645 Invalid offset in Kernel image section
646 Unable to extract command1 from AuxInfo for FrontPanel_Part3