5790B
Service Manual
4-14
800-Level Faults: Calibration constant
800 Bad Cal Constant ID
801 Bad Cal Group ID
802 Save Operation Failed
803 Save Operation Complete
900-Level Faults: Normal measurement
900 A/D Measurement Failed
901 Protection Activated
902 Inguard is overloaded
903 Ground Protection Activated -- Press Reset
904 DC Zero Cal Needed -- Go to Calibration in Setup Menu
1000-Level Faults: Non-volatile storage
1001 Repaired missing or corrupted NV files
1002 Unknown NV constant
1100-Level Faults: Analog operations manager
1100 Guard Crossing Protocol Failed To Start
1101 Analog Hardware Initialization Failed
1102 Giving Up On Initializing Hardware
1103 NV Integrity Check Failed
1104 Analog Hardware Control Inoperative
1200-Level Faults: GPIB interface
1200 Error opening GPIB Controller
1201 Error setting GPIB Primary Address
1202 Error occurred reading characters from GPIB controller
1203 Error occurred sending characters to the GPIB controller
1204 GPIB DOS Error
1205 GPIB specified Interface Board is not Active Controller
1206 GPIB no present listening devices
1207 GPIB interface Board has not been addressed properly
1208 GPIB invalid argument
1209 GPIB specified Interface Board is not System Controller
To Next Page
Loading...
