Maintenance
Error Codes 4
4-15
1210 GPIB I/O operation aborted (time-out)
1211 GPIB non-existent GPIB board
1212 GPIB routine not allowed during asynchronous I/O operation
1213 GPIB no capability for operation
1214 GPIB File system error
1215 GPIB command byte transfer error
1216 GPIB serial poll status byte lost
1217 GPIB SRQ stuck in ON position
1218 GPIB table problem
1300-Level Faults: Remote interfaces
1300 Bad Syntax
1301 Unknown command
1302 Bad Parameter Count
1303 Bad Keyword
1304 Bad Parameter Type
1305 Bad Parameter Unit
1306 Bad Parameter Value
1307 488.2 I/O DEADLOCK
1308 488.2 INTERRUPTED Query
1309 488.2 UNTERMINATED Command
1310 488.2 Query After Indefinite Response
1311 Invalid From GPIB Interface
1312 Invalid From Serial Interface
1313 Unknown command
1314 Parameter Too Long
1315 Invalid Device Trigger
1316 *DDT Recursion
1317 Macro Calls Too Deep
1318 Remote Serial Port Dead
1320 Command Applies To Wideband Only
1321 Command Does Not Apply Wideband
1337 Already Executing a Procedure
1338 Already Writing to NV Memory
1339 MEAS? Timed-Out
To Next Page
Loading...
