Fluke 64 max User Manual

IR Thermometer
Overview
17
Note
You cannot save a reading if the memory is full. If you push SET to save a new
reading when the memory is full, the last record flashes twice to remind you that the
memory is full, and the reading is not saved.
To delete a single saved reading:
• In record review status, push and hold SET for approximately 3 seconds. The reading
flashes once and is deleted.
After the deletion, all remaining records move one position forward. For example, if the
deleted record was in position “08”, then the record on “09” becomes the new “08”
record.
To delete all saved readings:
• In record review status, push and hold SET for approximately 10 seconds. At 3 seconds,
the display flashes to warn that all data will be lost. Continue to push SET to delete all
the records. To cancel this operation, release SET before you reach 10 seconds.
Once all records are deleted, the record count returns to “00”.
1.888.610.7664 info@Fluke-Direct.com
Fluke-Direct.com

Fluke 64 max Specifications

General

Product color	Black, Yellow
Response time	500 ms
Spectral response	8 - 14 µm
Temperature measurement range	-30 - 600 °C
Temperature measurement units	F, °C
Battery life	30 h
Battery type	AA
Number of batteries supported	1
Operating altitude	0 - 2000 m
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 50 °C
Display technology	LCD

Weight and Dimensions

Depth	75 mm
Width	85 mm
Height	175 mm
Weight	255 g