64 Max
Users Manual
16
SAVE and Review the Records
To save readings:
1. Pull the trigger to take a measurement.
2. Release the trigger to stop the measurement and go back to HOLD status.
3. Push SET to save the reading.
R and a two-digit number below it shows on the display for approximately 1 second
and then disappears. This means that the reading has been saved into memory at the
two-digit location. The Product also saves a time and date stamp and the EMS value.
To review saved readings:
1. In HOLD status, push SEL
to step through the first level menu until Rshows on the
display. The latest record shows on the display. The record includes the reading, EMS
value, and the date and time stamp.
2. Push or to review each record. A two-digit number below Rshows the current
record number (from 01 to 99).
1.888.610.7664 info@Fluke-Direct.com
Fluke-Direct.com
To Next Page
Loading...
