64 Max
Users Manual
20
Auto Capture
Use this feature to make a measurement at a specific time (within 24 hours) or to make
repeated measurements (Interval monitoring).
For a one-time measurement: The Product automatically wakes up at the specified time,
makes a measurement, and saves the reading. Once the reading is saved, the feature turns
off. To make a one-time measurement:
1. In HOLD status, push SEL >3 seconds to enter the second-level menu.
2. Push SEL until AUTO CAPTURE and TIME show on the display.
3. Push SET to switch the feature on or off.
4. When it is on, push or to adjust the time.
5. Push SEL several times or pull the trigger to exit the setup.
Note
• When the Auto Capture feature is on, AUTO CAPTURE shows on the
display when the Product is in SCAN and HOLD status.
• If the memory is full (all 99 positions of data storage are occupied), you
cannot turn on this feature.
1.888.610.7664 info@Fluke-Direct.com
Fluke-Direct.com
To Next Page
Loading...
