Fluke 64 max User Manual

IR Thermometer
Overview
19
Lock the Measurement
Use this feature to take continuous readings automatically without the need to pull the trigger.
To use the lock feature:
1. In HOLD status, push SEL for approximately 3 seconds to enter in the second level
menu.
 shows on the display.
2. Push SET to enable the lock feature. The product exits the setup and starts to
continually measure.
3. Push SET or pull the trigger to stop the measurement as necessary. The Product returns
to setup status.
Trigger Lock
This feature conserves battery power when the Product is stored. For example, if the Product
is stored inside a toolbox so that the trigger is pulled for >10 minutes, the Product turns itself
off to save the battery. To use this feature:
1. In HOLD status, push SEL for approximately 3 seconds to enter the second-level menu.
2. Push SEL until TRIG L shows on the display.
3. Push SET to switch the feature on or off.
4. Push SEL several times or pull the trigger to return to HOLD status.
1.888.610.7664 info@Fluke-Direct.com
Fluke-Direct.com

Fluke 64 max Specifications

General

Product color	Black, Yellow
Response time	500 ms
Spectral response	8 - 14 µm
Temperature measurement range	-30 - 600 °C
Temperature measurement units	F, °C
Battery life	30 h
Battery type	AA
Number of batteries supported	1
Operating altitude	0 - 2000 m
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 50 °C
Display technology	LCD

Weight and Dimensions

Depth	75 mm
Width	85 mm
Height	175 mm
Weight	255 g