IR Thermometer
Maintenance
27
Maintenance
Caution
To avoid damage to the Product, do not leave the thermometer on or near
objects of high temperature.
Change the Battery
To install or change the AA IEC LR06 battery, open the battery compartment and replace the
battery as shown in Figure 14.
Note
To prevent the loss of the set date, time, and status of appointment and monitoring,
remove and insert a new battery when the Product is in sleep mode and complete
the operation within 10 seconds.
Clean the Product
Use soap and water on a damp sponge or soft cloth to clean the Product case. Carefully wipe
the lens surface with a moist cotton swab. The swab may be moistened with water. See
Figure 15.
1.888.610.7664 info@Fluke-Direct.com
Fluke-Direct.com
To Next Page
Loading...
