68x Series
Getting Started
16
EXIT/STOP Press G to stop the currently running test, to exit a
function (such as Setup or Help), to return to the top-level
softkeys, to return up hyperlink paths, to respond to a
pop-up menu prompt, or close a pop-up window.
Pressing G from a Configuration Menu or Station List
Menu saves the changes you have made to non-volatile
memory and exits the Menu.
TAB Use B in the following situations:
1. For most tests that display station addresses, press
B to switch the address display format from
symbolic name, dotted decimal, manufacturer prefix,
and hexadecimal. Selecting the Address Mode
softkey also allows this selection by use of a menu.
2. In tests that display configuration fields and scroll
lists on the same screen, such as Station Ping, press
B to move between configuration parameters and
output results.
3. From the top-level softkeys, press B, then press
I to switch between the Token Ring and
Ethernet interface (Fluke 686 and 685 only).
4. To jump between hyperlink objects press B, or
press H, then B to jump backwards between
hyperlink objects.
PRINT Use D in the following situations:
1. Press D to output the graphic image of the current
screen to the serial printer port or to the instrument’s
virtual disk. This depends on the Output Type
parameter in File Manager’s configuration.
2. To print scrollable lists and ASCII reports, press
C, Print All, or H, then D. Tests must be
stopped to print ASCII information.
3. For some tests, after you stop a test you can press and
release H, then D to print all of the
information collected by the test.
MENU Press C to access the pop-up test and configuration
menus.
UP/DOWN & Press M, L, K, and J for display
To Next Page
Loading...
