Thermocouple Calibrator
Auto Power-Off
13
Auto Power-Off
The Product provides an auto power-off function to save
power. When the auto power-off mode is enabled, the
Product automatically powers off after 15 minutes of
inactivity.
To enable the auto power-off mode:
1. Push .
2. When SHIFT shows on the display, push .
3. In the displayed setting list, highlight the Auto
poweroff option, and then use to select this option.
To disable the the auto power-off mode:
1. Push .
2. When SHIFT shows on the display, push .
3. In the displayed setting list, highlight the Auto
poweroff option, and then use to deselect this
option.
Display Contrast Adjustment
The Product allows you to adjust the display contrast.
To adjust the display contrast:
1. Push until Measure shows on the display.
2. Push to darken contrast, or to lighten contrast.
Auto Backlight-Off
The Product provides an auto backlight-off function to
save power. When the auto backlight-off mode is enabled,
the backlight automatically turns off after 2 minutes of
inactivity.
To enable the auto backlight-off mode:
1. Push .
2. When SHIFT shows on the display, push .
3. In the displayed setting list, highlight the Auto
backlight off option, and then use to select this
option.
To disable the the auto backlight-off mode:
1. Push .
2. When SHIFT shows on the display, push .
3. In the displayed setting list, highlight the Auto
backlight off option, and then use to deselect this
option.
To Next Page
Loading...
