Fluke 714C - Scale Ma Channel to Temperature; Set 0 % and 100 % Output Parameters

714C
Users Manual
22
Scale mA Channel to Temperature
The Product provides a function to convert mA current
channel reading to temperature reading.
To scale mA channel to temperature:
1. Push .
2. Push .
The temperature reading shows on the display.
To switch back to mA channel:
1. Push .
2. Push .
The mA current reading shows on the display.
Note
Temperature at 4 mA = Span check 0 %
Temperature at 20 mA = Span check 100 %
Set 0 % and 100 % Output Parameters
You must set the 0 % and 100 % points before you can
use the step and ramp functions or use mA/temperature
conversion. Proceed as follows:
1. If necessary, push  for Source mode.
2. Push  and use the arrow keys to enter the correct
type.
3. Use the arrow keys to adjust the value.
4. Push  and  (or ) to set 100 % and 0 %
value.
Note
This function is only available when Source
mode is selected.