714C
Users Manual
16
Measure Temperature
Use Thermocouples
The Product supports 17 standard thermocouples,
including types E, N, J, K, T, B, R, S, L, U, C
(W5Re/W26Re), BP, XK, G, D, P, or M. Table 6
summarizes the ranges and characteristics of the
supported thermocouples.
To measure temperature using a thermocouple, proceed
as follows:
1. Attach the thermocouple leads to the appropriate TC
miniplug, then to the TC input/output as shown in
Figure 7.
Note
One pin is wider than the other. Do not try to
force a miniplug in the wrong polarization.
If the Product and the thermocouple plug are at
different temperatures, wait one minute or more
for the connector temperature to stabilize after
you plug the miniplug into the TC input/output.
2. If necessary, push for MEASURE mode.
3. Push
for the TC display. If desired, continue
pushing this key to select the desired thermocouple
type.
Set Temperature Unit
The Product allows you to select the temperature unit °C
or °F.
Push to switch to shift mode, and push to set the
temperature unit to °C or °F.
The default temperature unit is °C.
To Next Page
Loading...
