Fluke 773 Instruction Sheet

772/773/773-II English Instruction Sheet
Page 1
772/773/773-II
Milliamp Process Clamp Meter
Instruction Sheet
Introduction
The hand-held, battery-operated Fluke 772/773/773-II Milliamp Process
Clamp Meters (the Meter or Product) can be used in troubleshooting
transmitters, valves, PLC and DCS I/O. Unlike conventional clamp meters,
the Meter features a remote jaw that is connected to the main body via
extension cable.
Features
• In-circuit measurement of 0 mA to 24 mA dc and up to 99.9 mA dc
using a remotely connected clamp via extension cable
•
0 mA to 24 mA dc
sourcing and simulating
•
0 V to 10 V dc sourcing (773/773-I
I)
•
Loop power supp
ly 24 V dc output
•
0 V to 30 V dc measurement (773/773-II)
• Scaled mA output (773/773-II)
• Simultaneous mA measurement
via detachable clamp and mA
sourcing (773/77
3-II)
•
250 Ω HAR
T resistor for mA source
•
Electronic zero
•
Percentage span (0 % to 100 %)
•
Hold
•
Auto power off (b
attery saver)
• Display
backlight
• Measurement sp
otlight LED
PN 3351049
Februa
ry 2009 Rev. 2, 6/23
© 2009-2023 Fluke Corporation. All rights reserved.
All product names are trademarks of their respective companies. Specifications are subject to
change without notice.

Fluke 773 Specifications

General

Operating altitude	0 - 2000 m
Storage temperature (T-T)	-25 - 60 °C
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	0 - 90 %
Battery type	AA
Power source	Battery
Battery voltage	1.5 V
Battery technology	Alkaline
Number of batteries supported	4
Product type	Digital multimeter
Product color	Grey, Red, Yellow
DC current range	0 - 0.024 A
DC voltage range	0 - 30 V
Placement supported	Handheld multimeter
Basic accuracy (DC current)	0.2% + 2 counts

Weight and Dimensions

Depth	44 mm
Width	70 mm
Height	246 mm
Weight	410 g