Preparing the Meter for Operation
Connecting to Line Power 2
2-7
Connecting to Line Power
XW Warning
To avoid shock hazard, connect the factory supplied three-
conductor line power cord to a properly grounded power outlet.
Do not use a two-conductor adapter or extension cord; this will
break the protective ground connection. If a two-conductor
power cord must be used, a protective grounding wire must be
connected between the ground terminal and earth ground
before connecting the power cord or operating the instrument.
First verify that the line voltage selection is set to the correct position, and then that the
correct fuse for that line voltage is installed. Connect the Meter to a properly grounded
three-prong outlet.
Table 2-2. Line Power Cord Types Available from Fluke
Type Voltage/Current Fluke Model Number
North America 120V/15A LC-1
North America 240V/15A LC-2
Universal Euro 220V/16A LC-3
United Kingdom 240V/13A LC-4
Switzerland 220V/10A LC-5
Australia 240V/10A LC-6
South Africa 240V/5A LC-7
LC-1 LC-2 LC-3 LC-4
LC-5 LC-6 LC-7
alh3.eps
Figure 2-3. Line Power Cords Types Available from Fluke
To Next Page
Loading...
