Fluke 8846A User Manual

B-1
Appendix B
Errors
Introduction
Listed below are the error messages the Meter uses to indicate a problem.
AC Line frequency too high
Invalid calibration step number
*TRG/GET received but was ignored
488.2 I/O deadlock
488.2 interrupted query
488.2 query after indefinite response
488.2 unterminated command
A fatal error occurred configuring the serial port
A fatal error occurred opening the serial port
AC Line frequency too low
Acknowledgement queue full
ACPOLE: all CAPDAC settings are too high
ACPOLE: all CAPDAC settings are too low
ACPOLE: no CAPDAC setting is close enough
Bad CRC
Bad keyword
Bad parameter value
Cal reference value out of tolerance
Cal secured
CAL? only works if you are calibrating
Calibration Aborted
Calibration measurements out of tolerance
Calibration steps out of sequence

Fluke 8846A Specifications

General

Frequency Range	3 Hz to 300 kHz
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
Resistance Range	10 Ω to 1 GΩ
Continuity	Yes
Diode Test	Yes
Temperature Measurement	Yes
Display	5.5 digit
Connectivity	USB, RS-232, GPIB
DC Current Range	100 µA to 10 A
AC Current Range	100 µA to 10 A
Frequency Accuracy	0.01 %
Capacitance Range	1 nF to 100 µF
Display Type	VFD
Power Supply	100 V to 240 V
AC Voltage Accuracy	±(0.06% + 0.03% of reading)
Resistance Accuracy	±(0.01% + 0.001% of reading)