Fluke 8846A - Output Data

Digital Multimeter
Introduction
81
Table 30. Execution Error Codes and Descriptions (cont.)
Error Code Error Text Description
512 RS-232 fatal error A fatal error occured opening the serial port.
513 RS-232 Configuration
error
A fatal error occured while configuring the serial port.
514 Command allowed only
with RS-232
Three commands which are only allowed with the
RS-232/Ethernet interface are SYSTem:LOCal,
SYSTem:REMote, and SYSTem:RWLock (in Fluke 45
emulation mode – the commands are LOCS, REMS, RWLS,
and LWLS..
520 Command line too long The command line exceeded 350 characters.
521 Input buffer overflow
522 Output buffer overflow
531 Insufficient memory There is not enough memory to store the requested number of
readings in internal memory using the INITiate command. The
product of the sample count (SAMPle:COUNt) and the trigger
count (TRIGger:COUNt) must not exceed 5,000 readings.
550 Command not allowed
in local
The multimeter received a READ? command while in the local
mode. For RS-232 operation, you should always execute the
SYSTem:REMote command before sending other commands
over the interface.
Table 31. Ethernet/GPIB Configuration Errors
Error Code Error Text Description
560 GPIB fatal error A fatal error occured opening the GPIB port.
570 GPIB primary address An error occured attempting to set the GPIB primary address.
572 GPIB Read An error occurred while attempting to read characters from the
GPIB port.
580 EDVR GPIB - DOS Error.
581 ECIC GPIB - Specified GPIB Interface Board is Not Active Controller.
583 EADR GPIB - Interface Board has not been addressed properly.
584 EARG GPIB - Invalid argument.
585 ESAC GPIB - Specified GPIB Interface Board is not System
Controller.
586 EABO GPIB - I/O operation aborted (timed out).
587 ENEB GPIB - Non-existent GPIB board.
588 EOIP GPIB - Routine not allowed during asynchronous I/O operation.
589 ECAP GPIB - No capability for operation.
590 EFSO GPIB - File System Error.
591 EBUS GPIB - Command byte transfer error.