8845A/8846A
Programmers Manual
82
Table 31. Ethernet/GPIB Configuration Errors (cont.)
Error Code Error Text Description
592 ESTB GPIB - Serial poll status byte lost.
593 ESRQ GPIB - SRQ stuck in ON position.
594 ETAB GPIB - Table problem.
801 ENET Port number Port value is out of range (1024 to 65535).
802 ENET Server Could not open the ethernet port.
803 ENET Timeout Time-out occured while opening the ethernet port.
1000 Unknown function Unknown Function Selection.
1001 Unknown range Unknown Range Selection.
1002 Unknown CCO Unknown Calibration Constant.
1003 Can’t set NPLC Illegal/Unknown NPLC Selection.
1004 Can’t set trigger Illegal/Unknown TRIGGER Selection.
1005 Can’t get DCV Gains Cannot get 1V/10V DC linearization constants.
1006 Line Freq High AC Line frequency too high.
1007 Line Freq Low AC Line frequency too low.
1008 Write CCO failure Calibration Constant write failed.
65535 Unknown Unknown Error.
Table 32. Calibration Errors
Error Code Error Text Description
701 CAL Secure Code Case Invalid characters in calibration secure code. The secure code
must contain only characters 0-9 and A-Z. No lower case or
other special characters are allowed.
702 CAL Secure Cal secured.
703 CAL Secure code Invalid secure code.
704 CAL Secure code too
long
Secure code too long.
706 CAL Invalid step
number
Invalid calibration step number.
707 CAL Reference Cal reference value out of tolerance.
708 CAL Not calibrating CAL? only works if you are calibrating.
709 CAL Abort Calibration aborted.
710 CAL Sequence Calibration steps out-of-sequence.
711 CAL No measurement No measurements taken during calibration.
712 CAL Overload Overload at input during calibration.
713 CAL Too far Calibration measurements out-of-tolerance.
To Next Page
Loading...
