Fluke 9062 - Page 19

Motor & Phase Rotation Indicator
Maintaining the 9062
15
The 9062 uses a 9 V battery (supplied). To replace the battery, follow these steps and refer
to Figure 4:
1. Disconnect test leads from any power source.
2. Remove the holster.
3. Place the 9062 face down on a nonabrasive surface and loosen the battery-door screw
with a flat-blade screwdriver.
4. Lift the battery access lid away from the 9062.
5. Replace the battery as shown in Figure 4. Observe the battery polarity shown in the
battery compartment.
6. Secure the battery access lid back in position with the screw.
7. Place the 9062 back in the holster.