Chapter 7: Maintenance
Update the Software
99
Use LinkWare Live to Update the Software
1 Use an appropriate cable to connect the tester’s RJ45 Ethernet
port to a network port, or connect a Wi-Fi adapter to the
tester’s type A USB port.
2 On the home screen, tap the SYNC icon.
3 For a wireless network, if the network selection screen shows,
connect to a network:
a. Select a network.
b. Enter security information.
c. Go back to the previous screen, then tap CONNECT.
d. Go back to the home screen, then tap SYNC.
4 On the LWL SIGN IN screen, enter the ID and password for
your LinkWare Live account, then tap SIGN IN.
5 If a software update is available, the tester shows a message.
Tap YES to install new software in your tester.
6 The tester reboots when the update is completed.
7 To install the update in a remote or another main tester, use
the USB cable provided to connect the updated main tester to
the other tester. See Figure 32.
8 Follow the instructions shown on the display of the updated
main tester.
To Next Page
Loading...
