STANDARDS INFORMATION D - 1
APPENDIX D
STANDARDS INFORMATION
D.1 SCPI Conformance Information
All commands comply to the SCPI standard 1994.0, except for the following:
-The
*
RST condition of the SENSe:VOLTage<n>[:DC]:RANGe:AUTO ON |
OFF command.
Exception: After
*
RST, autoranging MTB is switched off.
-The
*
RST condition of the SENSe:SWEep:TIME:AUTO ON | OFF command.
Exception: After
*
RST, autoranging attenuators CH1, CH2, CH3, and CH4
are switched off.
- The <device> parameter of the HCOPy:DEVice <type> command.
Exception: The HCOPy:DEVice command allows to select the hardcopy
device by specifying its name or type number, e.g., <type> =
HPLASER or LQ1500.
In addition, the following commands are implemented:
- The CALCulate:TRANsform:FREQuency:TYPE ABSolute | RELative command.
Purpose: To allow the selection of absolute or relative FFT calculation.
- The TRIGger[:SEQuence[1] | STARt]:VIDeo:FORMat[:TYPE] <type>
command.
Purpose: To allow the selection of a TV standard by specifying its name
or abbreviation, e.g., <type> = HDTV.
- The SYSTem:SET? <node_number> query.
Purpose: To allow the instrument settings to be saved and restored in
functional groups (nodes) as specified by the <node_number>.
To Next Page
Loading...
