Fluke CombiScope PM3370B - Page 284

E - 2 SUMMARY OF SYSTEM SETTINGS
18
Delayed timebase settings
length = 13 bytes
delayed timebase, trigger mode edge, TV, trigger level, delayed
timebase on/off, trigger slope pos/neg, noise suppression on/off,
trigger source CH1/2/3/4, mtb, trigger delay, trigger coupling AC,
DC, LF reject, HF reject.
19
Event trigger delay settings
length = 9 bytes
event counter, event trigger level, event trigger source CH1/2/3/4,
event triggering on/off, event trigger slope pos/neg, event trigger
coupling AC, DC.
20
SCPI trigger source
length = 4 bytes
SCPI_trigger_source IEEE-bus, immediate, CH1/2/3/4.
32
Cursor settings
length = 33 bytes
voltage/time cursors on/off, rise time on/off, cursor control volt/time,
Vpp on/off, rise time 10-90%/20-80%, voltage readout Vpp/Vp-
Vp+, readout on/off: delta-V, absolute V1&V2, voltage ratio, delta-
T, 1/delta-T, time ratio, time phase, Vdc, X cursor 1/2, Y cursor 1/2,
X/Y ratio, cursor source CH1/2/3/4, track & delta control, ref. &
delta control, degrees cursors horizontal and vertical selection,
V1&V2 readout, dBm/dBµV/ Vrms readout, FFT ref. impedance
50Ω/600Ω, digital source cursor 1/2 CHn, Mi_j, magnify factor
delta-X/Y ratio.
33
Cursor autosearch settings
length = 18 bytes
autosearch cursors on/off, edge1/2, cursor display reference,
absolute/relative readout, Cas_level cursor 1/2, Cas_reference
cursor 1/2 min, max, low, high, gnd, abs, Cas_upper/lower_level
cursor 1/2.
49 | 50
MEASurement 1/2 settings
length = 10/8 bytes
measurement on/off, slope first + second source pos/neg, measure
type dc, rms, peak-up, peak-down, peak-to-peak, histogram top,
histogram bottom, overshoot, preshoot, delay, frequency, period,
pulse, rise time, fall time, duty cycle, MEAS1/2 source CHn, Mi_j,
bytes 9+10 not used (only applicable for MEAS1).
51
Pass/Fail test settings
length = 20 bytes
Pft on/off, envelope, meas1, meas2, cursor, no action, beep, stop,
save source at fail, start hardcopy at fail, draw upper/lower range,
Pft cursor define, Pft test range type, delta_V, V1, delta-T, 1/delta-
T, greater than, lower than, range test,
Pft_source/destination/save_register, Pft_higher/lower_limit,
Pft_vertical/horizontal_draw_position.