DSP-4000 Series
Users Manual
4-14
Single Test Results for Twisted Pair Cabling
The Single Test results for twisted pair cabling are identical to those displayed by
an Autotest, with exceptions noted in the following paragraphs.
Tests not required by the selected test standard produce a Warning result when
measured values exceed the test’s limits.
Wire Map
Wire map results are identical to the Autotest version. See “Wire Map” in Chapter
3 for details. The Single Test version of the wire map test includes the scanning
function.
Length
If a remote is connected, the length test and results are identical to the Autotest
version. See “Length” in Chapter 3 for details.
If a remote is not connected, the test tool displays the message NO REMOTE
DETECTED, and the limit and result columns are not shown. If the length of a
cable pair cannot be determined, the length value on the display is blank and
WARNING appears in the result column.
NEXT and NEXT@REMOTE
The NEXT test and results are identical to the Autotest version. See “NEXT” in
Chapter 3 for details.
The NEXT@REMOTE test and results are identical to the Autotest version. See
“NEXT@REMOTE” in Chapter 3 for details.
ELFEXT
The ELFEXT test and results are identical to the Autotest version. See Chapter 3
for details.
To Next Page
Loading...
Need help?
General
