DSP-4000 Series
Users Manual
2-36
Editing the Report Identification
The report identification includes a custom header (your company name, for
example), an operator name, and a site name. These items appear on saved
Autotest reports. You can view and edit this information as follows:
1. Turn the rotary switch to SETUP.
2. Use D to highlight Edit under Report Identification; then
press E. The REPORT IDENTIFICATION display shows the information
that will appear on the Autotest reports you save.
3. Use D U to highlight the information you want to edit; then press E.
If you are editing an operator or site name, you can press @ New to add a
new name. The New softkey appears only if less than 20 names have been
entered. If 20 names have been entered, you must delete a name before adding
a new name.
To rename or delete an existing operator or site name, press ! Edit,
select the desired name; then press ! Rename or @ Delete.
Changes to names preceded by a "$" appear on printed test reports. You
cannot delete a name that is used on a saved report.
4. To add characters to the name, use the L R and D U keys to highlight
characters in the list, then press E.
To delete the character left of the cursor, press $Delete.
To edit characters in the middle of a name, use !Å to move the cursor into
the name.
To move the cursor back to the right-most character, press !Å until the
cursor wraps back to the right.
To increment or decrement an alphanumeric character anywhere in the cable
identification, use !Å to highlight the desired character; then
press @INC or #DEC.
5. To store the name, press S.
Note
You can use LinkWare software to download report identification
information from a PC to the test tool.
To Next Page
Loading...
Need help?
General
