Fluke DSP-4100 - Page 212

DSP-4000 Series
Users Manual
2
test connections, 2-12, 3-3
test standard selection, 2-35
Battery
charging, 2-4
lithium, 8-3
NiMH
removal and replacement, 8-2
when to replace, 8-2
power-down timer, 2-42
status messages, 2-44
Beeper, enabling/disabling, 2-42
—C—
Cable
basic troubleshooting, 7-27
configuring a custom test, 6-4
construction, coaxial and twisted pair, 7-1
identifying hub port connections, 4-22
interface for PC, 8-20
interface for printing, 5-3
pin connections for 568 standard, 7-3
Cable ID
auto sequence, 2-38
changing, 3-30, 5-2
incrementing, 2-37
list status, 2-40
selecting downloaded list, 2-39
Cable type
selecting, 2-35
selecting, quick start, 2-8
Calibration
factory, 6-1
NVP, 6-3
permanent link interface adapter, 6-3
self-calibration, 6-1
Certifications, 8-23
Channel
description, 7-6
test connections, 2-13, 3-4
test standard selection, 2-35
Characteristic impedance. See Impedance
Compliance, 8-23
Configure custom test, 6-4
Connectors
main unit, 2-19
remote, 2-22
RJ11 (telephone), 2-3
Crossed pair,wire map display, 3-9
Crossed wires,wire map display, 3-9
Crossover cable, 7-29
Custom test configuration, 6-4
—D—
Date, 2-41
Delay skew test, 3-11
explanation of test, 7-18
Display
adjusting contrast, 2-34
size, 8-24
Duplicate I.D., 3-28
—E—
ELFEXT
explanation of test, 7-12
plot description, 3-18
results screen items, 3-17
EMC, 8-21
—F—
False test results, 8-4
Fault anomaly threshold (twisted pair), 3-11
Fault info. See Automatic diagnostics
Fault Info key, 3-7
Fluke Networks, contacting, 1-1
Frequency, 350 MHz, 2-35
Front panel
main unit, 2-19
remote, 2-21
Full-duplex transmission, 7-26
—H—
HDTDR test
effects of termination results, 4-10
example plots, 7-29
explanation of HDTDR, 7-20
interpreting the plot, 7-23
plot description, 4-12
results screen items, 4-12
twisted pair and coaxial cable, 4-9, 7-20
HDTDX analyzer
example plots, 7-29