Fluke DSP-4100 - Page 215

Index (continued)
5
Self test
failure, 8-3
how to run, 2-32
Self-calibration, 6-1
Serial port
cable for printer interface, 5-3
configuring for printing, 5-3
connection for printing, 5-4
error, printing, 5-6
interface description, 8-19
Setup
configuring the test tool, 2-33
downloading from a PC, 2-33
list of settings, 2-29
quick setup, 2-8
Shield continuity test, enabling, 2-35
Short,wire map display, 3-9
Single test
tests for twisted pair, 4-1
Single Test
tests for coaxial cabling, 4-16
Smart remote. See Remote
Softkeys description, 2-19
Special functions, list of functions, 2-30
Split pair
explanation of split pair, 7-16
Split pair,wire map display, 3-9
Standards
CSA, 8-23
incompatible versions, 5-2
safety, 8-23
Storage, 8-2
Store plot data
selecting, quick start, 2-8
Strap, 2-26
Switch modes, 2-26
—T—
Talk mode, 2-15
Terminator
connection during length test, 3-26
connection during resistance test, 3-26
effects on HDTDR test, 4-10
Test standard
descriptions of standards, 2-27
selecting, 2-35
selecting, quick start, 2-8
Time, 2-41
Tone generator, 4-26
Top level pass* indication, 2-9
Traffic monitor, 4-19
Troubleshooting
finding cabling faults, 7-27
troubleshooting the test tool, 8-3
—U—
Using this manual, 1-6
—V—
Version
hardware, 2-31
software, 2-31
test standards, 2-31
Viewing saved reports, 5-2
quick start, 2-11
Voice communication, 2-15
—W—
Warning messages
battery voltage messages, 2-44
characteristic impedance warning, 3-11
excessive noise detected, 2-33
excessive voltage detected, 2-32
incompatible standards versions, 5-2
printed reports, 3-32
test result memory is now full, 3-31
test summary result, 3-11
the previous test results have not been
saved, 3-2
unable to save test results, 3-31
warning in test results, 4-14
Wire map
description of test, 3-8
displays, 3-8
pin connections for 568 standard, 7-3
Worst margin
ELFEXT, 3-17
NEXT, 3-14
Worst margin results, 3-6
Worst value
ELFEXT, 3-17
NEXT, 3-14
Worst value results, 3-6