Fluke Hydra Series II - Page 18

2635A
Users Manual
xvi
CH
20
...
10
...
0
Selecting a Channel. Select Channel 0 with the
up/down arrow keys. Notice each key entry is
acknowledged with a short "beep." Try the
left/right arrow keys and notice a long beep.
Short beeps represent correct entries; long beeps
represent incorrect entries. [Figure 2-3]
A
B
ENTER
ENTER
Auto
10.000 M
3.0000 M
300.00 k
30.000 k
3.0000 k
300.00
SET FUNC
2T
4T
SET FUNC
Selecting a Measurement Scale. Select the
300.00 scale with up/down arrow keys, then
press ENTER. [Figure 2-6]
Selecting a Terminal Configuration.
Resistance measurements for channels 1
through 10 can use two channels (4 terminals) for
increased precision. For channels 0 and 11 to
20, only 2 terminal (2T) connections are allowed.
Press ENTER. [Figure 2-6]
FUNC
ENTER
SET FUNC
OFF
°F [°C]
Hz
Ω
VAC
V DC
Selecting a Function. Press FUNC to open the
function menu, use up/down arrow keys to select
Ω, then press ENTER. [Figure 2-6]
op79_2f.eps
Ten Minute Tour (cont)