Fluke Hydra Series II - Maximum AC Input; Typical Scanning Rate

Appendices
Specifications A
A-13
Maximum AC Input
300V rms or 424V peak on channels 0, 1, and 11
150V rms or 212V peak on channels 2 to 10 and 12 to 20
Voltage ratings between channels must not be exceeded
2 x 10
6
Volt-Hertz product on any range, normal mode input
1 x 10
6
Volt-Hertz product on any range, common mode input
Cross-Talk Rejection
Refer to Appendix B.
Typical Scanning Rate
See table below. The measurement conditions are: averaged rate over 20 scans;
continuous scanning; alarm limits and Mx+B scanning set on all channels; logging data
to internal memory; and RS-232 communications set at 9600 baud. Measurements were
taken with short-circuit inputs on all channels, except frequency, which was taken with
5V at 15 Hz on all channels.
Table A-17. Typical Scanning Rate
CHANNELS
FUNCTION RANGE SLOW FAST
1 10 20 1 10 20
VDC 300 mV 1.8 3.9 4.1 2.5 13.7 18.4
3V 1.8 3.9 4.1 2.5 13.7 18.4
30V 1.8 3.9 4.1 2.5 13.7 18.3
150/300V 1.8 3.9 4.1 2.5 13.6 18.2
AUTO 1.7 3.6 3.9 2.4 11.3 14.1
TEMPERATURE J (TC) 1.0 3.3 3.8 2.1 12.2 16.6
PT (RTD) 1.7 3.1 3.2 2.1 6.0 6.7
VAC 300 mV 1.1 1.5 1.6 1.3 2.5 2.6
3V 1.1 1.5 1.6 1.3 2.5 2.6
30V 1.1 1.5 1.6 1.3 2.5 2.6
150/300V 1.1 1.5 1.6 1.3 2.5 2.6
AUTO 1.1 1.5 1.5 1.3 2.4 2.5
OHMS 300Ω 1.7 3.1 3.2 2.1 6.0 6.7
3 kΩ 1.7 3.1 3.2 2.1 6.0 6.7
30 kΩ 1.7 3.1 3.2 2.1 6.0 6.7
300 kΩ 1.2 1.8 1.8 1.7 4.0 4.4
3 MΩ 1.2 1.6 1.7 1.7 3.9 4.2
10 MΩ 1.1 1.6 1.6 1.7 3.8 4.0
AUTO 1.7 3.1 3.2 2.1 6.0 6.7
FREQUENCY ANY 0.5 0.6 0.6 0.6 0.7 0.7