Flybox Eclipse - CON1 Connections

CON1 connections
25-pin D-sub plug, view from wiring side
TABLE 1 CON1 CONNECTIONS
Pin # Description
1
+12V Main supply
2
GND Main supply
3
GND
4
Not used/Reserved
5
GND for GPS serial input (connect to copper shield of Flybox® GPS cable)
6
TX signal of external GPS (RS232 level and polarity)
7
CAN0
H
signal for connection with ECLIPSE MFD (connect to pin#7 of MFD)
8
Not used/Reserved
9
CAN1
L
signal for connection with ACU (see chap. 10.3.3)
10
+ (positive ) microphone input (currently not used)
11
GND
12
Not used/Reserved
13
Not used/Reserved
14
Not used/Reserved
15
Not used/Reserved
16
+5V for GPS (connect to red wire of Flybox® GPS)
17
GPS TX (connect to black wire of Flybox® GPS)
18
Altitude serial out for transponder
19
GND for altitude serial out (connect to copper shield)
20
CAN0
L
signal for connection with ECLIPSE MFD (connect to pin#20 of MFD)
21
CAN1
H
signal for connection with ACU (see chap. 10.3.3)
22
GND
23
- (negative) microphone input (currently not used)
24
High level audio output
25
GND
10