Oil temperature sensors
The supported types of oil temperature sensors are:
- ROTAX preinstalled sensor:
Connect it to pin #10 of CON2 connector.
- JABIRU preinstalled sensor:
Connect it to pin #10 of CON2 connector.
- PT1000 resistive sensors:
Connect it between ground and pin #10 of CON2 connector.
Oil pressure sensors
The supported types of oil pressure sensors are:
- ROTAX 4-20mA:
installed on 912/914 engines produced after 2008/05.
- Flybox® P/N 602000:
compatible with the Rotax 4-20mA sensors.
- ROTAX resistive sensors:
installed on 912/914 engines produced before 2008/05.
- JABIRU oil pressure sensors.
RPM pickup input
Standard RPM input support Rotax 912/914 pickup and other similar types of tachometer transducer. Connect the transducer
output to pin #19 of CON2 connector.
Outside air temperature sensor
(OAT)
The supported types of OAT sensors are:
- PT1000 resistive sensors:
Connect one wire to pin #11 of CON2 connector and the other wire to aircraft ground.
Flybox® OAT sensor:
Flybox® OAT sensor is a PT1000 and can be fixed with a 5 mm countersunk screw.
For optimal outside temperature indication it must not be installed in direct sunlight locations or near heat sources.
Airbox/carburetor air temperature sensor
(CAT)
The supported types of CAT sensors are:
- PT1000 resistive sensors:
Connect one wire to pin #29 of CON2 connector and the other wire to aircraft ground.
Flybox® CAT sensor:
Flybox® CAT sensor is a PT1000 with a M10x1 thread.
16
Probe retainer
Nut
Thermocouple
Probe coupling
To Next Page
Loading...