Flybox Eclipse - CHT Gauge Setup; Gauge Setup Menu

OILT type : type of oil temperature sensor installed:
P1K: PT1000 resistive sensor
ROX: ROTAX oil temperature sensor
JAB: JABIRU oil temperature sensor
OILP type : type of oil pressure sensor installed:
420: ROTAX 4-20mA (engine from 2008/05) or Flybox® P/N 602000 sensors
RES: ROTAX Resistive (engine before 2008/05)
JAB: JABIRU oil pressure sensor
CAT type : type of carburetor air temperature sensor installed:
P1K: PT1000 resistive sensor
NO: no CAT sensor installed
NOTE: If you use original Flybox® CAT sensors select “P1K” type.
OAT type : type of outside air temperature sensor installed:
P1K: PT1000 resistive sensor
NO: no OAT sensor installed
NOTE: If you use original Flybox® OAT sensors select “P1K” type.
FP sensor : YES/NO. Select whether you installed or not the Flybox® fuel pressure sensor.
AMP sensor : YES/NO. Select whether you installed or not the Flybox® current sensor.
AMP offset : Calibration of battery current sensor. See “Current sensor” in chap.4.
6.1.2 Gauge setup menu
In gauge setup menu you will configure the setpoints/limits
for all the measurements.
- Rotate the knob to navigate through the menu items.
- Press the knob to enter in the selected item.
WARNING : Default parameters are suitable for Rotax
912/914 engine but its still essential, before using ECLIPSE in
flight, check that all parameters are correct for your engine.
• CHT GAUGE SETUP
26