Flybox Eclipse - AMP Gauge Setup; ASI Gauge Setup; Fuel Pressure Gauge Setup; Volt Gauge Setup

• FUEL PRESSURE GAUGE SETUP
Max : set the top limit of the fuel pressure gauge.
High : set the transition pressure from green to high red zone of the fuel pressure gauge.
Low : set the transition pressure from low red to green zone of the fuel pressure gauge.
Min : set the bottom limit of the fuel pressure gauge.
• VOLT GAUGE SETUP
Max : set the top limit of the voltage gauge.
High : set the transition voltage from green to high red zone of battery voltage.
Low : set the transition voltage from low red to green zone of battery voltage.
Min : set the bottom limit of the voltage gauge.
• AMP GAUGE SETUP
Max : set the top limit of the current meter gauge.
Low : set the transition voltage from yellow to green zone of the current meter gauge.
Min : set the bottom limit of the current meter gauge.
• ASI GAUGE SETUP
NOTE: The default speed are all set to zero. Its mandatory to check your aircraft characteristics speed and set the following
parameters accordingly.
Vne-Vno-Vfe-Vs-Vs0 : Set the speed setpoint for the moving tape airspeed indicator (see next picture).
Vy : Set the Vy of your aircraft.
Vx : Set the Vx of your aircraft.
Unit : Set the unit of measure for the air speed indicator in kilometers per hour (Km/h), miles per hour (Mph) or knots (Kts).
29
High
Max
High
Max
Low
Low
Min
Min
Min
Low Max