Flybox Eclipse - Page 57

•
CONNECTIONS DETAIL FOR ACU CON4P CONNECTOR
Pin # Description
1
CAN bus communication line: CAN-H signal
2
+12V main supply
3
CAN bus communication line: CAN-L signal
4
GND main supply
•
CONNECTIONS DETAIL FOR ACU CON8P CONNECTOR
Pin # Description
1
GND for Pitch Servo
2
Not used
3
GND for Roll Servo
4
Not used
5
+12V for Pitch Servo
6
Not used
7
+12V for Roll Servo
8
Not used
•
CONNECTIONS DETAIL FOR FX75 SERVO CONNECTOR
Pin # Description
1
+12V power supply
2
Not used
3
Not used
4
CAN bus communication line: CAN-L signal
5
CAN bus termination
6
GND power supply
7
Not used
8
Not used
9
CAN bus communication line: CAN-H signal
10
CAN bus termination
NOTE: The CAN bus termination (pin#5 connected with pin#10) must be done only on the last servo of the
CAN bus line. If you install only one servo, the CAN line must be terminated on that servo.
57