Flymaster SD+ - 4.7.9 RF Probes

Table 4.4: Language/Units Menu Options
Function Description
Language Denes the interface language.
Alti. Units Altitude Units. Altitude can be show in Meters, or Feet.
Roc. Units Rate of Climb Units. ROC can be show in m/s, or 10 x Feet/ min
Dist. Units Distance units can be in Km, or Miles.
Speed Units Speed Units can be in Km/h, Miles/h, or Knots.
Temperature Temperature units can be Celsius or Farenheit.
Coords. Coordinates format. These can be either:
 DD ° MM'SS?
 DD ° MM.mmm'
 DD.dddd
 UTM
4.7.8 Device Settings
This menu option allows the user to execute some recovery functions. A short description of the available
options is shown in Table 4.5.
Table 4.5: Device Settings
Function Description
Factory Settings Reset all parameters to the default factory values. This will not
change the layout to the factory default layout. Care should be
taken because all changes made by the user are lost.
Reset now Makes a hardware reset to the instrument. The result is the same
as the one presented in Section 1.5.
Auto-o If set to Yes the GPS SD+ turns o if the GPS speed is less than
5 km/h, and integrated vario less than +-1.5 m/s, for more than
30 seconds.
4.7.9 RF Probes
The RF Probes menu option allows the user to pair up any of the Flymaster wireless devices including
the M1 and Heart-G to the GPS SD+ . Pairing is performed automatically. When ENTER is pressed
the GPS SD+ will look to see what wireless devices are around and it will shows these on the screen (see
Figure 4.28). Devices are identied by their name (e.g. M1, TAS) and serial number. Devices can be
selected using the UP, or DOWN keys. For the selected (highlighted) device the pairing state is shown on
the bottom of the screen. To pair a device the state should be changed from No to Yes . Once paired the
GPS SD+ will always automatically connect with the wireless device. The GPS SD+ can be paired with
several devices.
37