Doc No: OMM50002312
Rev: C Page 29 of 54
Subject to contractual terms and conditions to the contrar
y, this document and all the information contained herein are the confidential and exclusive
property of FMC Technologies, and may not be reproduced
, disclosed, or made public in any manner prior to express written authorization by FMCTI.
3. Rock the fluid cylinder (34) to loosen from the cylinders
(37), and then pull free of the fluid end studs (59). If the
piston assemblies have already been removed, take care to
ensure that the cylinders do not fall off of the front of the
power end and become damaged.
4. To remove the piston assemblies, refer to steps 3 through 7
of the previous section.
5. Inspect all parts for signs of wear or damage. Replace parts
as necessary in accordance with the previous section.
6. Always replace the
cylinder gaskets (47)
when the cylinders have
been moved or replaced.
7. Reverse steps 2 through 6
to install the FMC W11
fluid cylinder (34).
8. Torque all fasteners as outlined in the Fastener Torque
Requirements, Section 11.0 of this manual. Note that if the
nuts (52) on the fluid cylinder studs (58, 59) are not
properly torqued, likelihood of pump failure is greatly
increased.
To Next Page
Loading...