Fora V10 - TEST STRIP INFORMATION

14
Test Strip
NOTE
The FORA V10 monitor should only be used with FORA V10 Test Strips.
Using other test strips with this meter can produce inaccurate results.
Absorbent Hole
Apply a drop of blood here.
The blood will be
automatically absorbed.
Conrmation Window
This is where you conrm if
enough blood has been
applied to the absorbent
hole in the strip.
Test Strip Handle
Hold this part to insert the
test strip into the slot.
Contact Bars
Insert this end of the test
strip into the meter. Push
it in rmly until it will go no
further.
ATTENTION:
Test results might be wrong if the contact
bar is not fully inserted into the test slot.
The front side of the
test strip should face
up when inserting
the test strip.
Front Back
1
4
3
2