Fora V10 - Page 23

23
Shake the control solution vial well.
Remove the cap from the control
solution bottle and place it on a at
surface. Squeeze the vial, discard the
rst drop, and wipe off the dispenser tip
to prevent contamination. Squeeze the
vial again to produce another drop and
place this drop on the top of cap.
Hold the meter up to meet the absorbent
hole of the test strip and the drop will
be automatically absorbed. Once the
conrmation window is completely lled,
the meter will start counting down.
To avoid contaminating the control solution with the contents of
the test strip, you will have to place a drop of control solution on
a clean surface. Do not directly apply control solution to a test
strip.
STEP 3 Obtain Control Solution
STEP 4 Apply Control Solution