WARNINGS
If your vehicle is fitted with a
Durashift EST transmission,
select a gear before switching off the
ignition.
Have the passengers leave the
vehicle.
Secure the diagonally opposite
wheel with an appropriate block
or wheel chock.
Do not work underneath the
vehicle when it is supported only
by a jack.
Make sure that the jack is
vertical to the jacking point and
the base is flat on the ground.
CAUTION
Do not lay alloy wheels face
down on the ground, this will
damage the paint.
1. Insert the flat end of the wheel
brace between the rim and the
hub cover and carefully remove
the hub cap or cover.
2. Install the locking wheel nut key.
3. Fully extend the wheel brace if
applicable.
4. Slacken the wheel nuts.
5. Jack up the vehicle until the tyre
is clear of the ground.
6. Remove the wheel nuts and the
wheel.
Installing a road wheel
WARNINGS
Use only approved wheel and
tyre sizes. Using other sizes
could damage the vehicle and will
make the National Type Approval
invalid. See Technical
specifications (page 140).
132
Wheels and tyres
To Next Page
Loading...
Need help?
General
